3,777
edits
SECTION 38: RUDDER PEDALS & BRAKE SYSTEM: Difference between revisions
Jump to navigation
Jump to search
SECTION 38: RUDDER PEDALS & BRAKE SYSTEM (view source)
Revision as of 05:40, 20 December 2022
, 20 December 2022→Page 38-8
m (→page 38-5) |
m (→Page 38-8) |
||
| Line 20: | Line 20: | ||
== Page 38-8 == | == Page 38-8 == | ||
==== Step 2 ==== | ==== Step 2 ==== | ||
* Before inserting the rudder cable consider adding a rudder cable fairing to your build. Avery makes a suitable fairing and is available from e.g. [https://www.aircraftspruce.com/catalog/appages/ruddercable.php Aircraft Spruce]. Draw lines 1 inch above and below the exit hole.<br>[[File:2022-10-09 16-06-00.jpg|400x400px]]<br>[[File:2022-10-09 17-14-23.jpg|400x400px]] | * Before inserting the rudder cable consider adding a rudder cable fairing to your build. Avery makes a suitable fairing and is available from e.g. [https://www.aircraftspruce.com/catalog/appages/ruddercable.php Aircraft Spruce]. Draw lines 1 inch above and below the exit hole.<br>[[File:2022-10-09 16-06-00.jpg|400x400px]]<br>[[File:2022-10-09 17-14-23.jpg|400x400px]]<br>See also [[Rudder_Cable_Fairings]]. | ||
* It's hard to | * It's hard to install the Adel-clamp which holds the sleeve at the tail end. Best to first get just the screw test threaded into the nut plate and backed out. Then capture just the cable with the adel clamp, hold the adel clamp closed with a temporary safety wire or a Hemostat and get the bolt in a few threads deep. Then remove the safety wire or Hemostat and capture and position the cable sleeve. Lastly tighten the bolt. | ||