3,763
edits
SECTION 27: FIREWALL: Difference between revisions
m
→PAGE 27-4
m (→PAGE 27-4) |
m (→PAGE 27-4) |
||
| Line 20: | Line 20: | ||
== PAGE 27-4 == | == PAGE 27-4 == | ||
* Step 1: In order to nest the aluminum and steel parts and make the holes align, it's necessary to file F-1001E-L/R as indicated in figure 1. | * Step 1: In order to nest the aluminum and steel parts and make the holes align, it's necessary to file F-1001E-L/R as indicated in figure 1. | ||
* Step 1: The WD-1004 nose gear tension fitting is the same part for left and right. The tooling hole will be on the upper rib on the left and the lower rib on the right side. | |||
* Step 6: The manual doesn't spell out that you need to dimple the screw holes of the K1100-08 nutplates. See page 26-2, step 5 as reference. | * Step 6: The manual doesn't spell out that you need to dimple the screw holes of the K1100-08 nutplates. See page 26-2, step 5 as reference. | ||
* Step 8: If you are planning to use the Andair fuel selector you might want to hold off riveting the F-1048C-1 Fuel Valve Bracket to the fwd fuselage ribs, as the Andair selector does not fit this bracket. | * Step 8: If you are planning to use the Andair fuel selector you might want to hold off riveting the F-1048C-1 Fuel Valve Bracket to the fwd fuselage ribs, as the Andair selector does not fit this bracket. | ||