Avionics / Panel: Difference between revisions
Jump to navigation
Jump to search
(Created page with "== Do's and Don'ts == * Don't remove any material from the ribs supporting the glare shield. You need to place the instruments so that they go left, right or underneath the ribs. * Don't remove the lowest part of the sub-panel to accommodate GPS units (the bottom part with its flange is structural). Rather cut a rectangular hole for the GPS with rounded edges to avoid stress into the sub-panel and reinforce the cut-out with angle brackets as mentioned in the build manual.") |
|||
| Line 1: | Line 1: | ||
== Do's and Don'ts == | == Do's and Don'ts == | ||
* Don't remove any material from the ribs supporting the glare shield. You need to place the instruments so that they go left, right or underneath the ribs. | * Don't remove any material from the ribs supporting the glare shield. You need to place the instruments so that they go left, right or underneath the ribs. | ||
* Don't remove the lowest part of the sub-panel to accommodate GPS units (the bottom part with its flange is structural). Rather cut a rectangular hole for the GPS with rounded | * Don't remove the lowest part of the sub-panel to accommodate GPS units (the bottom part with its flange is structural). Rather cut a rectangular hole for the GPS with rounded corners to avoid stress into the sub-panel and reinforce the cut-out with angle brackets as mentioned in the build manual. | ||
Revision as of 19:02, 21 March 2022
Do's and Don'ts
- Don't remove any material from the ribs supporting the glare shield. You need to place the instruments so that they go left, right or underneath the ribs.
- Don't remove the lowest part of the sub-panel to accommodate GPS units (the bottom part with its flange is structural). Rather cut a rectangular hole for the GPS with rounded corners to avoid stress into the sub-panel and reinforce the cut-out with angle brackets as mentioned in the build manual.