3,777
edits
SECTION 11: EMPENNAGE ATTACH: Difference between revisions
Jump to navigation
Jump to search
m
→Page 11-9
m (→Page 11-9) |
|||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 52: | Line 52: | ||
When installing bolts in the rod end bearings for the elevators and rudder, I used a set of hemostats w/ some blue tape on the tip to hold the bolts during the install. Worked great to take in/out of the bearings.<br>[[File:2023-12-23 16-41-04.jpg|Rod End Bearing installation|400px]] | When installing bolts in the rod end bearings for the elevators and rudder, I used a set of hemostats w/ some blue tape on the tip to hold the bolts during the install. Worked great to take in/out of the bearings.<br>[[File:2023-12-23 16-41-04.jpg|Rod End Bearing installation|400px]] | ||
==== Page 11-9 ==== | ==== Page 11-9 ==== | ||
* Step 2: Figure 2 specifies a cotter pin (MS24665-208) for the AN310-4 castle nut. Easy to miss as the line for it doesn't end near the castle nut. | |||
* Step 5: As a starting point, check these drawinging<br>[[File:Elev1.jpg|600px]]<br>[[File:Elev2.jpg|600px]]<br>The centered starting values for the trim cable nut positions are not very good and require painful iterations.<br>Goal is that both tabs go down 35 degrees, are in sync in neutral and the right tab goes up 25 degrees while the left one stays neutral in all up (see also section [[CHAPTER:_PRE_FIRST_FLIGHT]]). | * Step 5: As a starting point, check these drawinging<br>[[File:Elev1.jpg|600px]]<br>[[File:Elev2.jpg|600px]]<br>The centered starting values for the trim cable nut positions are not very good and require painful iterations.<br>Goal is that both tabs go down 35 degrees, are in sync in neutral and the right tab goes up 25 degrees while the left one stays neutral in all up (see also section [[CHAPTER:_PRE_FIRST_FLIGHT]]). | ||
* Good right cable starting values:<br>3 threads exposed at the servo clevis,<br>21.4 mm from where the green ends at the servo side to the first nut<br>40.5 mm from where the green ends at the trim tab side to the bracket end<br>1.5 mm exposed of the threads at the trim tab clevis. | * Good right cable starting values:<br>3 threads exposed at the servo clevis,<br>21.4 mm from where the green ends at the servo side to the first nut<br>40.5 mm from where the green ends at the trim tab side to the bracket end<br>1.5 mm exposed of the threads at the trim tab clevis. | ||
| Line 59: | Line 60: | ||
[[ | [[Category:Hints]] | ||