7
edits
SECTION 8: HORIZONTAL STABILIZER: Difference between revisions
Jump to navigation
Jump to search
→Builder Videos
m (→Page 8-13) |
|||
| (6 intermediate revisions by 3 users not shown) | |||
| Line 7: | Line 7: | ||
* You will need to build some wooden support braces (see page 8-7, step 5). | * You will need to build some wooden support braces (see page 8-7, step 5). | ||
=== Builder Videos === | |||
Minos Pilacoutas: | |||
* [https://youtu.be/WVlUTuYb-CQ Part 1] | |||
* [https://youtu.be/h7L9Gxo1xUw Part 2] | |||
* [https://youtu.be/MawqfhrBbfI Part 3] | |||
=== Notes === | === Notes === | ||
==== Page 8-2 ==== | |||
* Step 5: The manufactured head of the rivets attaching the doubler to the rear spar go onto the spar side to reduce the likelihood of interference with the elevator leading edge. This orientation is consistent with the instructions on page 8-13, figure 1. Also recall the general rule: Manufactured head on the thinner material. | |||
==== Page 8-3 ==== | ==== Page 8-3 ==== | ||
* | * Step 3: The 1 21/32 lower flange width dimension is to be applied at the 1 inch line, not at 2 inches, the raw angle size. | ||
==== Page 8-7 ==== | ==== Page 8-7 ==== | ||