SECTION 9: ELEVATORS: Difference between revisions

← Older edit

SECTION 9: ELEVATORS (view source)

Revision as of 14:25, 27 September 2025

80 bytes added , 27 September

m

Correct link

VisualWikitext

BDC

1

edit

@@ Line 6: / Line 6: @@
 Special/New Tools/Supplies
-* You will need more fuel-tank sealant for this section (see notes at the top of the [Rudder] section)
+* You will need more fuel-tank sealant for this section (see notes at the top of the [[SECTION 7: RUDDER|SECTION 7]])
 * More wooden supports need to be fabricated for this section
 * You can buy a pre-made [https://cleavelandtool.com/products/special-bar-for-rv-10-empennage special bucking bar] instead of fabricating one for page 9-12)
@@ Line 14: / Line 14: @@
 * Consider machined cable anchor brackets (see info for page 9-7 below)
-==== Builder Videos ====
+=== Builder Videos ===
 Plane Lady:
 *[https://www.youtube.com/watch?v=BXRYrk7uJf0 9-1 to 9-8]
 *[https://www.youtube.com/watch?v=TiQhEdeYOJQ 9-9 to 9-15]
+Minos Pilacoutas:
+* [https://youtu.be/HegFaib5j80 Part 1]
+* [https://youtu.be/Oai7BLpIrUo Part 2]
+=== Notes ===
 ==== Page 9-7 ====
@@ Line 65: / Line 72: @@
 '''Section 9-21 Trim Tab Templates'''
-* as svg files, they print correctly 1:1 with e.g. free Inkscape (https://inkscape.org/))<br>[[index.php?title=Media:Trailing edge foam ribs.svg|Trailing edge foam ribs.svg]]<br>[[index.php?title=Media:Trim tab foam ribs.svg|Trim tab foam ribs.svg]]<br>See also hints concerning printing at 1:1 scale in  [[SECTION_39:_CONTROL_SYSTEM]]
+* as svg files, they print correctly 1:1 with e.g. free Inkscape (https://inkscape.org/))<br>[[Media:Trailing edge foam ribs.svg|Trailing edge foam ribs.svg]]<br>[[Media:Trim tab foam ribs.svg|Trim tab foam ribs.svg]]<br>See also hints concerning printing at 1:1 scale in  [[SECTION_39:_CONTROL_SYSTEM]]
-[[index.php?title=Category:Hints]]
+[[Category:Hints]]