7
edits
SECTION 6: VERTICAL STABILIZER: Difference between revisions
→Builder Videos: Added videos from Minos Pilacoutas
(Added a "Before you Start" section) |
(→Builder Videos: Added videos from Minos Pilacoutas) |
||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 32: | Line 32: | ||
*[https://www.youtube.com/watch?v=ZuUES4VUCUU 6-6 Step 1-4] | *[https://www.youtube.com/watch?v=ZuUES4VUCUU 6-6 Step 1-4] | ||
*[https://www.youtube.com/watch?v=gfCN35sLw08 6-6 Step 5-9] | *[https://www.youtube.com/watch?v=gfCN35sLw08 6-6 Step 5-9] | ||
Minos Pilacoutas: | |||
* [https://youtu.be/Oez-hdJOSHQ Part 1] | |||
* [https://youtu.be/RZAmoNAhORM Part 2] | |||
=== Notes === | |||
*When first putting the nose rib in, don't ram in in there and cleco. Be gentle, and it will probably need to be sanded down. Otherwise you will have "outtie" dents on the leading edge of your skin. | *When first putting the nose rib in, don't ram in in there and cleco. Be gentle, and it will probably need to be sanded down. Otherwise you will have "outtie" dents on the leading edge of your skin. | ||
*These ribs have been sanded a bit and the web was fluted at the tip trying to bring the flanges closer together, but it still wasn't enough. | *These ribs have been sanded a bit and the web was fluted at the tip trying to bring the flanges closer together, but it still wasn't enough. | ||
| Line 48: | Line 52: | ||
* Page 6-5, Figure 2: This may be your first time using AN3 bolts. Be sure to refer to the torque specs in Section 5 and consider adding torque seal as well. Torque specs don't apply to the AN509 machine screws, however. | * Page 6-5, Figure 2: This may be your first time using AN3 bolts. Be sure to refer to the torque specs in Section 5 and consider adding torque seal as well. Torque specs don't apply to the AN509 machine screws, however. | ||
[[ | [[Category:Hints]] | ||