Wing Tips: Difference between revisions
Jump to navigation
Jump to search
| (10 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
== Kit Deletions == | == Kit Deletions == | ||
* If you | * If you are going with 3rd party wing tips, delete the following from the wing kit: | ||
** W-1015-L (left tip) | ** W-1015-L (left tip) | ||
** W-1015-R (right tip) | ** W-1015-R (right tip) | ||
** VA-193 (pair of lenses) | ** VA-193 (pair of lenses) | ||
** Bag 967 (lens hardware) | ** Bag 967 (lens hardware) | ||
Note: Vans may no longer allow deleting parts. Depends on the kit. | |||
==== Companies providing aftermarket Wing Tips ==== | |||
[ | *[https://www.aveoengineering.com/ziptips-premiere/ Ziptips] | ||
*[https://aeroleds.com/products/aerosun-vxi/ Aerosun] | |||
== Wing Tips Installation Hints == | |||
* [https://www.youtube.com/watch?v=6wbl6SZOGZQ Rodrigo Damazio Bovendorp time laps video 1] | |||
* [https://www.youtube.com/watch?v=06sokZegpFw Vic Syracuse video] | |||
* [https://www.facebook.com/groups/vansrv10/posts/5277567609030962 FB thread on wiring up the Ziptip rear lights to the connector] | |||
* When installing per Van's instructions, it is important to rig the ailerons before to ensure alignment with the trailing edge of the wing tip (note: elevator position influences aileron slightly). | |||
* The Zip Tips are not as flexible as Van's and getting them to match can be challenge. There is a note in the RV-14 manual using a ratchet strap that I found helpful.<br>[[File:RV-14 note.png|600px]] <br>[[File:Strap.png|400px]] | |||
* If you have received Vans part W-1016, it will show you the amount of "bending" you will have to give the wingtip. Below is a picture comparing W-1016 to the insert that comes with the Zip Tips.<br>[[File:W-1016 comparison.png|400px]] | |||
== Zip Tips Power Measurements == | |||
* Landing light: 2.28A per side | |||
* Taxi light: 1.5A per side | |||
* Nav light: 0.65A per side | |||
* Strobe: 2A average per side (14% duty cycle, 14A per side when flash occurs) | |||
== Tail Light Removal == | |||
* A tail light is not needed when using Zip Tips. See CFR title 14 volume 1 section 23.1385 (c): Rear position light. The rear position light must be a white light mounted as far aft as practicable on the tail '''or on each wing tip'''. | |||
[[Category:Options]] | |||
[[ | |||
Latest revision as of 16:25, 14 February 2025
Kit Deletions
- If you are going with 3rd party wing tips, delete the following from the wing kit:
- W-1015-L (left tip)
- W-1015-R (right tip)
- VA-193 (pair of lenses)
- Bag 967 (lens hardware)
Note: Vans may no longer allow deleting parts. Depends on the kit.
Companies providing aftermarket Wing Tips
Wing Tips Installation Hints
- Rodrigo Damazio Bovendorp time laps video 1
- Vic Syracuse video
- FB thread on wiring up the Ziptip rear lights to the connector
- When installing per Van's instructions, it is important to rig the ailerons before to ensure alignment with the trailing edge of the wing tip (note: elevator position influences aileron slightly).
- The Zip Tips are not as flexible as Van's and getting them to match can be challenge. There is a note in the RV-14 manual using a ratchet strap that I found helpful.
- If you have received Vans part W-1016, it will show you the amount of "bending" you will have to give the wingtip. Below is a picture comparing W-1016 to the insert that comes with the Zip Tips.
Zip Tips Power Measurements
- Landing light: 2.28A per side
- Taxi light: 1.5A per side
- Nav light: 0.65A per side
- Strobe: 2A average per side (14% duty cycle, 14A per side when flash occurs)
Tail Light Removal
- A tail light is not needed when using Zip Tips. See CFR title 14 volume 1 section 23.1385 (c): Rear position light. The rear position light must be a white light mounted as far aft as practicable on the tail or on each wing tip.