SECTION 24: WING TIP: Difference between revisions
Created page with "Cutting the lens is easy - use your tin snips and then sand to get the edges straight. I would suggest waiting until the wings are on the plane and the ailerons rigged before you drill these. I did them in the jig while vertical since I liked the access - put the flaps to the stop, lined up the ailerons and figured I'd be good. Outcome was that I was 1/4" low, and had to cut the back edge apart to be able to adjust the wing tip so it would align nicely with the aileron."
(Created page with "Cutting the lens is easy - use your tin snips and then sand to get the edges straight. I would suggest waiting until the wings are on the plane and the ailerons rigged before you drill these. I did them in the jig while vertical since I liked the access - put the flaps to the stop, lined up the ailerons and figured I'd be good. Outcome was that I was 1/4" low, and had to cut the back edge apart to be able to adjust the wing tip so it would align nicely with the aileron.") |
(No difference)
|