3,777
edits
SECTION 24: WING TIP: Difference between revisions
m
no edit summary
(Added an image for the fix...) |
mNo edit summary |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
=== Build Instruction Updates === | |||
* N/A | |||
Check for more recent updates [https://www.vansaircraft.com/service-information-and-revisions/?aircraft=rv-10&doctype=revisions-changes&sort=date here] | |||
=== Hints === | |||
[[File:WingtipAlignment.jpg|thumb]] | [[File:WingtipAlignment.jpg|thumb]] | ||
Cutting the lens is easy - use your tin snips and then sand to get the edges straight. Using a Dremel melts it and it leaves a bulky burr. | Cutting the lens is easy - use your tin snips and then sand to get the edges straight. Using a Dremel melts it and it leaves a bulky burr. | ||
| Line 7: | Line 12: | ||
Then you can move everything back into alignment, fill with flox, to glue it back together. There is a layer of fiberglass on the inside that was folded to connect top and bottom. Replaced that with two layers of BID. Not too bad, but likely could have been avoided. | Then you can move everything back into alignment, fill with flox, to glue it back together. There is a layer of fiberglass on the inside that was folded to connect top and bottom. Replaced that with two layers of BID. Not too bad, but likely could have been avoided. | ||
[[Category:Hints]] | |||