Aerosport Hints: Difference between revisions
Jump to navigation
Jump to search
| Line 6: | Line 6: | ||
* [https://www.youtube.com/watch?v=HlTjJ18s_oc Installation Video] | * [https://www.youtube.com/watch?v=HlTjJ18s_oc Installation Video] | ||
* Rear end bulk head interface, see this [https://www.facebook.com/groups/vansrv10/posts/5681512561969796 FB Thread] | * Rear end bulk head interface, see this [https://www.facebook.com/groups/vansrv10/posts/5681512561969796 FB Thread] | ||
==== Armrest with Throttle Quadrant ==== | |||
* [https://www.aerosportproducts.com/wp-content/uploads/2018/06/armrest.pdf Installation Instructions] | |||
* [https://www.youtube.com/watch?v=tjVtVQIsTVs Installation Video] | |||
* Good tools for trimming carbon fiber: | |||
** [https://www.panamericantool.com/novar-pencil-grinder.html Pencil grinder] | |||
** [https://www.homedepot.com/p/Dremel-1-1-4-in-Rotary-Tool-Carbide-Cutting-Shaping-Wheel-for-Use-on-Woods-Fiberglass-Plastics-and-Laminates-543/202315728 Dremel Cutting / Shaping Wheel] | |||
* Hints | |||
** If you have the Aerosport panel with a center console, the fore/aft position is determined by mating the arm rest with the center console. | |||
** If you have a stock panel, the fore/aft position is determined by where you want the fuel valve handle to sit. Not too close behind the throttle quadrant so you can reach it and not too for forward as the throttle quadrant may be too far aft.<br>Steps: | |||
*** Make a roughly 2.5 x 4.5 inch doubler for the Andair fuel valve from 64 to 80/1000 inch thick aluminum. | |||
*** Put a 30-31 mm hole in the middle. | |||
*** Clamp the doubler below the Vans fuel valve bracket with the center hole aligned. | |||
*** Pick 6 locations and drill #30 holes with good edge distance for 1/8th rivets to secure the doubler to the Van's bracket. | |||
Revision as of 13:22, 18 July 2023
Hints for installing Aerosport Interior Products
Front side panels
- The recessed map pockets / cup holders occupy the space between the outer skin and the inside wall thus interfering with thicker battery cables or AC hoses that might be run across this section.
Overhead Console
- Installation Video
- Rear end bulk head interface, see this FB Thread
Armrest with Throttle Quadrant
- Installation Instructions
- Installation Video
- Good tools for trimming carbon fiber:
- Hints
- If you have the Aerosport panel with a center console, the fore/aft position is determined by mating the arm rest with the center console.
- If you have a stock panel, the fore/aft position is determined by where you want the fuel valve handle to sit. Not too close behind the throttle quadrant so you can reach it and not too for forward as the throttle quadrant may be too far aft.
Steps:- Make a roughly 2.5 x 4.5 inch doubler for the Andair fuel valve from 64 to 80/1000 inch thick aluminum.
- Put a 30-31 mm hole in the middle.
- Clamp the doubler below the Vans fuel valve bracket with the center hole aligned.
- Pick 6 locations and drill #30 holes with good edge distance for 1/8th rivets to secure the doubler to the Van's bracket.