Avionics / Panel

Do's and Don'ts

• Don't remove any material from the ribs supporting the glare shield. You need to place the instruments so that they go left, right or underneath the ribs.
• Don't remove the lowest part of the sub-panel to accommodate GPS units (the bottom part with its flange is structural). Rather cut a rectangular hole for the GPS with rounded corners to avoid stress into the sub-panel and reinforce the cut-out with angle brackets as mentioned in the build manual.
• Don't put your backup attitude indicator (e.g. a G5) out of sight (on the copilot side, down on the center console)
• Don't put your IFR certified GPS out of sight (more than 45 degrees to the right, more than 30 degrees down), unless you install a full annunciator panel in sight.

Panel Builders

• Aerotronics [1]
• Stein Air [2]

Avionics Dealerships

• Aerotronics
• Aircraft Spruce
• Pacific Coast Avionics
• Sarasota
• Stein Air