Avionics / Panel: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 1: | Line 1: | ||
== Do's and Don'ts == | ==== Do's and Don'ts ==== | ||
* Don't remove any material from the ribs supporting the glare shield. You need to place the instruments so that they go left, right or underneath the ribs. | * Don't remove any material from the ribs supporting the glare shield. You need to place the instruments so that they go left, right or underneath the ribs. | ||
* Don't remove the lowest part of the sub-panel to accommodate GPS units (the bottom part with its flange is structural). Rather cut a rectangular hole for the GPS with rounded corners to avoid stress into the sub-panel and reinforce the cut-out with angle brackets as mentioned in the build manual. | * Don't remove the lowest part of the sub-panel to accommodate GPS units (the bottom part with its flange is structural). Rather cut a rectangular hole for the GPS with rounded corners to avoid stress into the sub-panel and reinforce the cut-out with angle brackets as mentioned in the build manual. | ||
== Panel Builders == | ==== Panel Builders ==== | ||
* Aerotronics [http://www.aerotronics.com/] | * Aerotronics [http://www.aerotronics.com/] | ||
* Stein Air [https://www.steinair.com/] | * Stein Air [https://www.steinair.com/] | ||
==== Avionics Dealerships ==== | |||
* [http://www.aerotronics.com/ Aerotronics] | |||
* [https://www.aircraftspruce.com/menus/av/index.html Aircraft Spruce] | |||
* [https://www.pacificcoastavionics.com/ Pacific Coast Avionics] | |||
* [https://sarasotaavionics.com/g3x Sarasota] | |||
* [https://www.steinair.com/product-category/avionics/ Stain Air] | |||
Revision as of 20:38, 22 March 2022
Do's and Don'ts
- Don't remove any material from the ribs supporting the glare shield. You need to place the instruments so that they go left, right or underneath the ribs.
- Don't remove the lowest part of the sub-panel to accommodate GPS units (the bottom part with its flange is structural). Rather cut a rectangular hole for the GPS with rounded corners to avoid stress into the sub-panel and reinforce the cut-out with angle brackets as mentioned in the build manual.