View source for SECTION 36: BRAKE LINES

=== Build Instruction Updates ===
* N/A
Check for more recent updates [https://www.vansaircraft.com/service-information-and-revisions/?aircraft=rv-10&doctype=revisions-changes&sort=date here]

== Hints ==
[[Hints for installing TS Flightline hoses]]

==== Page 36-2 ====
* Step 2 - The hole in the landing gear mount might need to be enlarged a bit to 7/16 to make the elbow fitting go through. Works best with a 7/16 reamer (e.g. $21 at [https://www.yardstore.com/reamer-chucking-7-16 Yardstore]).<br>The elbow fitting doesn't quite stick out enough to get a wrench on it when torquing the nuts. Consider adding a AN960-716 / NAS1149F0763 washer sneaked in between the bottom skin and the weldment so that the washer sits between the fitting and the weldment on the bottom side.<br>If you are working alone, it works well to use heavy duct tape and fixate a 7/16 wrench on the bottom skin to hold the elbow fitting in the right direction when torquing the nuts inside.
* Figure 2 - If you have a return fuel line (e.g. SDS electronic injection), the brake line goes into the aft of the 3 holes, not the center hole as illustrated in figure 2.

[[Category:Hints]]